Product ID:SEMI-GLOSS POLYURETHANE, 677
MSDS Date:01/06/1988
FSC:8010
NIIN:00N052467
MSDS Number: BVMJF

FARWEST PAINT MANUFACTURING CO

4522 S 133RD ST
TUKWILA, WA 98168
US

Emergency Phone: 206-941-1619

Info Phone: 206-244-8844

Cage: 2F266

FARWEST PAINT MANUFACTURING CO

TUKWILA, WA 98168 US

Telephone: 206-244-8844

Cage: 6F266

ALIPHATIC HYDROCARBON; (SOLVENT; ALIPHATIC HYDROCARBON). VP

Fraction By Weight: 53-58%

OSHA PEL 500 PPM (MFR)

ACGIH TLV: 100 PPM (MFR)

2.0 @68F

Fraction By Weight: <1%

OSHA PEL 500 PPM (MFR)

ACGIH TLV: 100 PPM (MFR)

STREAMS, OR OTHER BODIES OF WATER. IF RUN-OFF

RTECS: 9999999ZZ

USE ONLY W/ADEQ VENT. KEEP OUT OF REACH OF

RTECS: 9999999ZZ

SHOULD BE IMPLEMENTED TO REDUCE EXPOS.

RTECS: 9999999ZZ

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE:EYES:CAN CAUSE SEV IRRIT,
REDNESS, TEARING, BLURRED VISION. SKIN:PRLNGD/RPTD CONT CAN CAUSE
MOD IRRIT, DEFAT, DERM. INHAL:EXCESSIVE BRTHG OF VAP CAN CAUSE
NASAL & RESP IRRIT, DIZZ, WEAK, FATG, N AUS, HDCH, POSS UNCON, &
EVEN ASPHY. INGEST:CAN CAUSE GI IRRIT, NAUS, VOMIT, & DIARR, ASPIR
OF MATL (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:HLTH HAZ:INTO LUNGS CAN CAUSE CHEM PNEUM WHICH
CAN BE FATAL.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid:SKIN:THORO WASH EXPOS AREA W/SOAP & WATER. REMOVE CONTAMD
CLTHG. LAUNDER CONTAMD CLTHG BEFORE RE-USE. EYES:FLUSH W/LG AMTS OF
WATER, LIFTING UPPER & LOWER LIDS OCCASNLY FOR AT LEAST 15 MIN, GET
MED AT TN. INGEST:DO NOT INDUCE VOMIT. KEEP PERSON WARM, QUIET, &
GET MED ATTN. ASPIR OF MATL INTO LUNGS DUE TO VOMIT CAN CAUSE CHEM
PNEUM WHICH CAN BE FATAL. INHAL:IF AFFECTED, REMOVE INDIVIDUAL
(SUPDAT)

Flash Point Method:TCC
Flash Point:100F,38C
Lower Limits:1.0%
Extinguishing Media:FOAM, CO*2, DRY CHEMICAL.
Fire Fighting Procedures:NIOSH/MSHA SCBA W/FULL FACEPIECE OPERATED IN
PRESS DEMAND/OTHER POSITIVE PRESSURE MODE.
Unusual Fire/Explosion Hazard:NEVER USE NEAR/AROUND WELDERS OR CUTTING
TORCHES. DRUM (EVEN EMPTY) BECAUSE PRODUCT (EVEN JUST RESIDUE) CAN
IGNITE EXPLOSIVELY.

Spill Release Procedures:SM SPILL:ABSORB LIQ ON PAPER, VERMICULITE,
FLOOR ABSORB, OR OTHER ABSORB MATL & TRANSFER TO HOOD. LG
SPILL:ELIM ALL IGNIT SOURCES( FLARES, FLAMES INCLDG PILOT LIGHTS,
ELEC SPARKS), PERSONS NOT WEARING PROT EQUIP SHOULD BE EXCLUDED
FROM AREA (SUPDAT)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:CNTNRS OF THIS MATL MAY BE HAZ WHEN
EMPTIED. SINCE EMPTIED CNTNRS RETAIN PROD RESIDUES (VAP, LIQ, &/OR
SOLID), ALL HAZARD PRECAUT MUST BE OBSERVED.
Other Precautions:COMBUSTIBLE. KEEP AWAY FROM HEAT & OPEN FLAME. USE
W/ADEQ VENT. AVOID PRLNGD CONT W/SKIN & BRTHG OF VAP/SPRAY MIST. DO
NOT TRANSFER CONTENTS TO BOTTLES/OTHER UNLABELED CNTNRS. CLOSE
CNTNR AFTER EACH U SE. DO NOT TAKE INTERNALLY. (ING 4)

Respiratory Protection:IF TLV OF PROD/ANY COMPONENT IS EXCEEDED, A
NIOSH/MSHA JOINTLY APPRVD AIR SUPPLIED RESP IS ADVISED IN ABSENCE
OF PROPER ENVIRON CONTORL. OSHA REG ALSO PERMIT OTHER NIOSH/MSHA
RESP UNDER SPECIFIED CNDT NS. ENGINEERING/ADMIN CONTROLS (ING 5)
Ventilation:SUFFICIENT MECHANICAL (GENERAL AND/OR LOCAL EXHAUST) VENT
TO MAINTAIN EXPOSURE BELOW TLV(S).
Protective Gloves:NITRILE RUBB RESISTANT GLOVES.
Eye Protection:ANSI APPVD CHEM WORK GOGG .
Other Protective Equipment:TO PVNT RPTD/PRLNGD SKIN CONT, WEAR
IMPERVIOUS CLTHG & BOOTS.
Work Hygienic Practices:KEEP WORK AREA CLEAN & FREE FROM LEAKS, &
SPILLS. ALWAYS WASH HANDS THORO W/SOAP & WATER BEFORE HDNGLG FOOD &
DRINK.
Supplemental Safety and Health
FIRST AID PROC:TO FRESH AIR. IF BRTHG IS DFCLT, ADMIN OXYG. IF BRTHG
HAS STOPPED, GIVE ARTF RESP. KEEP PERSON QUIET & GET MED ATTN.
SPILL RELEASE:OF SPILL TO PVNT SPREADING, PUMP LIQ TO SALVAGE TANK.
REMAINING LIQ MAY BE TAKEN UP ON SAND, CLAY, EARTH, FLOOR ABSORB,
OR OTHER ABSORB MATL. PVNT RUN-OFF TO SEWERS, (ING 3)

Boiling Pt:B.P. Text:300F,149C
Vapor Pres:SEE INGS
Vapor Density:HVR/AIR
Spec Gravity:0.931
Evaporation Rate & Reference:FASTER THAN ETHER
Solubility in Water:NIL
Appearance and Odor:CLEAR, YELLOW AMBER LIQUID WITH MILD, SWEET
AROMATIC ODOR
Percent Volatiles by Volume:<55

Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:KEEP AWAY FROM OPEN FLAMES SPARKS, AND
HEAT. DO NOT WELD NEAR/AROUND PRODUCT.
Hazardous Decomposition Products:NONE SPECIFIED BY MANUFACTURER.

Waste Disposal Methods:DESTROY BY LIQ INCIN. CONTAMD ABSORB MAY BE
DEPOSITED IN A LANDFILL I/A/W LOCAL, STATE, AND FEDERAL
REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.